Description
Crowtail ESP8266 Node MCU adds six crowtail interface on the board, so you can easily use the ESP8266 Iot board with other crowtail modules. With a USB-Serial chip to upload code. It also has auto-reset so no messing with pins and reset button. With connection for a Polymer 3.7V battery and built-in charger. Power, programming and charging from the micro USB port. Comes fully assembled and tested, with a USB interface, to use with the Arduino IDE or NodeMCU Lua. It comes pre-programmed with the Lua interpreter. With separate headers, solderable for use on a breadboard.
– Wiki
Crowtail ESP8266 Node MCU specifications:
– Dimensions: 50mm x 35mm
– ESP8266 @ 80MHz, with 3.3V logic/power
– 4MB FLASH (32 MBit)
– WiFi 802.11 b/g/n
– 3.3V regulator with 500mA peak current output
– CP2104 USB-Serial converter, 921600 max baud rate
– Auto-reset support
– 9 x GPIO pins with I2C and SPI
– 1 x analog inputs 1.0V max
– 100mA LiPoly charger with status LED
– Power/enable pin
– Reset button
Reviews
There are no reviews yet.